What a recirc pump is

A hot water recirculation pump is a small pump, usually about the size of a coffee can, mounted on the piping near the water heater. Some systems also have a small valve under the sink farthest from the water heater. The pump pushes hot water through the lines so it's already warm when you open the tap.
Not every house has one. If you look around the pipes on top of and beside the water heater and don't see a small pump with a cord or a timer, you probably don't have one, and you can skip this one.
Why it ends up running nonstop
- It was set to run all the time when it was installed and nobody ever changed it.
- It has a timer, but a power blip or an outage reset the clock, so it's running at the wrong hours or all day.
- The timer pins got pushed in or out by accident.
What you can safely check
- Find the pump and look for a timer or a switch. Many plug into an outlet through a dial timer, and some have a small digital clock on the pump.
- If the time on the timer is wrong, set it to the right time of day.
- Set it to run only during the hours you actually want faster hot water, like early morning and evening.
- If there's no timer and it just runs, write that down and mention it the next time you book a tune-up.
After you set the timer, run the hot water at the farthest bathroom during one of the "on" hours and one of the "off" hours. You'll know right away if the schedule is working.
When to call
Don't open the water heater, and don't work on gas burners, valves, or venting. If the pump is hardwired instead of plugged in, leave the wiring alone. Any water dripping at the pump or the pipes around it is a same-day call: (470) 999-7395. If you're not sure what you're looking at, or hot water is taking longer than it used to, call me at (470) 999-7395 or book online for a $79 diagnostic.





















































































